![]() |
| Vertical orientation today - good results on 40m WSPR TX |
This morning I tried to get a few more WSPR reports on 7MHz using my small ferrite rod antenna. I managed a few only, then after about 20 minutes I decided to try again with the ferrite VERTICAL on the desk. Don't ask me why I did this, but then I started getting a large number of spots!
![]()
Now, all other antennas were disconnected and I tried this arrangement in several places around the room and ALL got decent spots. Maybe what I have here is a bit of a hybrid. If you look at the diagram there are about 80turns on the rod beyond the parallel tuned circuit that I assumed was the magnetic loop doing the radiating. Then again you can consider the parallel tuned circuit as a base loading for the 80t short vertical above it. Tuning C1 will bring the whole system to resonance and a low SWR can be found by adjusting the tap point, which turned out to be best very close to the bottom, about 1 turn up. There is no earth connection. I make no claims as to how this works. Some suggest it is just an elaborate coupler into the house wiring, but the very sharp tuning makes me think this is not likely. Also, if this was the case then surely moving it around in the room would make a big difference? Below are the spots for a few hours on 40m.
![]() |
| WSPR spots with the antenna above on 40m today |
However it works, it manages to do pretty well. Now I do not believe in "snake oil" antennas, and make no claims for this one: a small ferrite rod will radiate something (H-field). Add a ferrite loaded vertical as well (an E-field antenna) and that will radiate too. What happens in the far field goodness only knows!
When the weather is better I will take the whole kit into the back garden well away from the house and repeat. If it is working without coupling into the house wires (as I think is the case) then results should be comparable. If spots disappear then it will have turned out to be a very good random wire coupler, HI.
![]()
![]()
